For replacing wheels on diesel and steam
engines easily and with the correct quartering.
Steam Engines will not run correctly if the
wheels are not set at the correct offset
to one another. Wheel guides must be purchased
separately, for each type wheel,
and are easily attached to the WHEEL PRESS.
Also available is a GEAR SPACING JIG. This
is used to set the drive gear on steam and
diesel axles in the correct place. The unit
may be used hand held or set in a vise. Adjustment
is provided for correct gauging, so that
the wheels are the correct distance from
each other. Supplied with instructions.
1606 WHEEL ALIGNMENT PRESS $125.00
WHEEL GUIDE SETS FOR USE WITH ALIGNMENT PRESS
SOLD SEPARATELY
1606A AF "S" GUIDE SET/ for most engines $75.00
1606B AF 0-8-0/0-6-0's GUIDE SET $75.00
1606C AF-ALCO/GP-7/BALDWIN DIESEL GUIDE SET $75.00
1606GJ GEAR SPACING JIG, for 1606A,B,C $15.00
WHEEL PULLER
Easy to use a must to remove steam or diesel
engine wheels without damage.
1600 Wheel Puller $39.95
RIVET / EYELET SETTING TOOLS
Use to professionally roll rivets or eyelet.
1601 3/16 - AF Chassis Eyelet Setting $16.00
For all 3/16" diameter Eyelets including
the eyelets used on later American Flyer
trucks and Pikemaster trucks.
1602 1/8 Rivet/ Eyelet Setting $16.00
For all 1/8" diameter Eyelets and Rivets
including the American Flyer front truck
rivets and tender draw bar rivets.
1605 1/16 - AF & Lionel Coupler knuckle rivet $16.00
Plus all other 1/16" diameter rivets
and eyelets.
1607 3/32 Rivet/Eyelet Setting $16.00
For all 3/32" diameter Eyelets and Rivets.
LINK PIN RESET
When replacing AF "S" & "O"
couplers the professional way. Sets the link
pin the same as the original installation.
1603 Link Pin Reset $12.99
LINK PIN REMOVAL
Two piece set to professionally remove AF
"S" & "O" link couplers
without damaging the coupler or truck. Consists
of a drive punch and an anvil. Comes with
instuctions.
1604 Link Pin Removal set $29.95
CHASSIS RIVET REMOVAL Two piece set to professionally remove AF
"S" & "O" chassis
rivets without damaging the truck.
Consists of a drive punch and an anvil. Comes
with instuctions.
1608 Chassis Rivet Removal set $29.95
SMOKE IN TENDER BELLOWS TOOL
Use this jig type tool to easily replace
the bellows material on American Flyer Smoke
in Tender units. Use on both "S"
and "HO". Use with # 2530 Bellows
Material And # 1151 Glue. Supplied with complete
easy to follow instructions, for an original
looking job.
K1610 Smoke in Tender Tool Kit
Tool/Bellows/Glue + Instructions $32.99
2530KIT Bellows Unit Repair Kit /Material+Glue 16.99
