3/16 SCALE TRACK TERMINAL No.690 A -Preferably use straight section of track and fasten as close to cross tie or sleeper as possible 1 -See Fig.1. Put shoulder shown as "A" against bottom of the inside rail. 2.-See Fig. 2. Press spring shown at "B" up and around bottom of other rail. 3.-See Fig. 3. Take wires shown as "C" and "D" cut off about one half inch of insulation from each end of wire, and connect clip "D" labeled "Base Post" to the Base Post Terminal on your transformer. Connect the other wire to Clip "C" and then to your transformer terminal marked "7-15 volts". If the terminal is used to supply track current to a piece of equipment, the wires "C'' and ''D" are connected to the two terminals on the equipment unless equipment instructions read otherwise. |